|
How to Order
The 360 Brake will ONLY fit aftermarket
billet wheels with a 5 hole bolt hole pattern and a minimum space of 6"
between the forks. A single 360 Brake is limited to 1000 lbs/bike & rider,
with a maximum payload of 1200 lbs. 360 Brake Company always recommends
that dual brakes be replaced with a dual 360 Brake set-up.
You must have the following information
ready when you place an order for your very own 360 Brake.
-
1. Axle
size? (360 Brake is 1" axle, can use reducer)
-
2. Wheel
Manufacturer or bolt hole pattern?
-
3.
Anti-rotation arm? (see Measurement Guides below)
-
4. Front or
Rear installation?
Click here for the
Order Form.
Click here for the
Wheel Manufacturer Fitment Guide. If your
wheel isn't listed here, you must use the Measurement Guides below to
determine your bolt hole pattern.
Click here for the
Measurement Guides.
Click here for the
Installation Guide for the new 360 Brake.
Click here for the
Installation Guide for the old 360 Brake.
Attention all 2008 Harley
Davidson Owners
Harley Davidson has changed the axle
size on the 2008 models to a 25mm axle. If you would like a 360 Brake for
your 2008 it will require that you change your axle to either a 1" or
3/4". 360 Brake Company will be offering a 1" axle for purchase at a
nominal fee in the near future to better serve our customers.
Customer Self-Installation Waiver
360 Brake wants to insure that
all units are installed correctly for the safety of the consumer. 360
Brake does not believe the installation of this brake is a simple bolt on
application. Installation requires the knowledge base of a professional.
If the consumer insists on installing the 360 Brake without the use of a
professional installation technician, we will require that the customer
sign the above document and in
doing so voids their warranty.
|
